Краткое Руководство По Установке для Ricoh ap204
11
Installing the PostScript2 kit Type 204
2
Important
❐ The RICOH-SCRIPT 2 can be dam-
aged by small amounts of static
electricity. Before touching it, touch
something metal to remove static
electricity from you.
electricity. Before touching it, touch
something metal to remove static
electricity from you.
A
Check the contents of the box for
the following items.
• DIMM (Dual Inline Memory
the following items.
• DIMM (Dual Inline Memory
Module)
• Installation Guide
B
Turn off the printer’s power switch
and remove all cables and cords
from the printer.
and remove all cables and cords
from the printer.
C
Remove both screws and remove
the printer board from the printer
as shown in the illustration.
the printer board from the printer
as shown in the illustration.
TPOP130E
Note
❐ A coin can be used to remove the
screws.
D
Align the module as shown in the
illustration. Tilt it upwards so that
it is 45 degrees from parallel to the
printer board (1
illustration. Tilt it upwards so that
it is 45 degrees from parallel to the
printer board (1
1
1
1
1), and slide it into
the slot. Then tilt it down so that
it is parallel to the board (2
it is parallel to the board (2
2
2
2
2). It
should make an audible click as it
pops into place.
pops into place.
TPOP160E
(a)
Note
❐ If the optional interface board
has been installed to the printer
board, you should remove it
from the board before installing
the module. After installing the
module, reattach the interface
board to its original position.
board, you should remove it
from the board before installing
the module. After installing the
module, reattach the interface
board to its original position.
❐ Be careful to notice that one side
has a notch (a). This is to prevent
you from installing the module
backwards.
you from installing the module
backwards.
Installing the RICOH-SCRIPT 2 Type204