Краткое Руководство По Установке для Ricoh ap204
13
Installing the Network Interface Board Type 204
2
Note
❐ Use a shielded network interface
cable.
❐ The network interface board can be
attached to either the front or the
back side of the printer board. This
procedure is for attaching to the
front side.
back side of the printer board. This
procedure is for attaching to the
front side.
❐ You cannot install two network in-
terface boards at a time.
A
Check the contents of the box for
the following items.
• Network interface board
• Ferrite core
• Installation Guide
the following items.
• Network interface board
• Ferrite core
• Installation Guide
B
Turn off the printer’s power switch
and remove all cables and cords
from the printer.
and remove all cables and cords
from the printer.
C
Remove both screws and remove
the printer board from the printer
as shown in the illustration.
the printer board from the printer
as shown in the illustration.
TPOP130E
Note
❐ A coin can be used to remove the
screws.
Installing the Network Interface Board
Type204
Type204
D
Remove both screws and the metal
plate from the printer board.
plate from the printer board.
TPOP170E
E
Insert the network interface board
into the slot and fasten it with both
screws that were removed in step
into the slot and fasten it with both
screws that were removed in step
DDDDD, as shown in the illustration.
TPOP180E