Release Note для Nortel 5380
Hardware Release Notes for the Model 5380 Ethernet and the Model 5580 Token Ring Routers
10
112772-A
Dialing into a Router through the System 5000 Service Port
The System 5000 service port has a male DB-9 connector that supports 3-wire
RS-232 signal (transmit, receive, and ground) with data leads for serial
asynchronous use only. To dial into the service port, set clear to send (CTS) and
data set ready (DSR) on your modem to “Forced On.” Refer to your modem
reference guide for instructions in setting these parameters to the values listed
in
RS-232 signal (transmit, receive, and ground) with data leads for serial
asynchronous use only. To dial into the service port, set clear to send (CTS) and
data set ready (DSR) on your modem to “Forced On.” Refer to your modem
reference guide for instructions in setting these parameters to the values listed
in
.
Table 1.
Modem and terminal parameter settings
Parameters
Settings
Modem
Baud rate
9600
Data bits
8
Stop bits
1
Parity
None
Clear to send (CTS)
Forced On
Data set ready (DSR)
Forced On
Data terminal ready (DTR)
Set to Ignore
Terminal
Baud rate
9600
Data bits
8
Stop bits
1
Parity
None
112772-ABook Page 10 Tuesday, December 17, 1996 6:54 AM