Инструкция для Canon imagePROGRAF iPF8400SE
Cause
Corrective Action
Because the Platen is soiled with ink or other substances, the size of the clear film
cannot be detected.
cannot be detected.
Open the Top Cover and clean the entire
Platen.
Platen.
Insufficient paper for job
Insufficient paper for job
Cause
Corrective Action
The printer has received a print job longer than the amount of roll paper left when
ManageRemainRoll in the Control Panel menu is On.
ManageRemainRoll in the Control Panel menu is On.
Press ▲ or ▼ to select Print, and then press
the OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
the OK button to resume printing.
However, the roll paper may run out during the
print job and you may not be able to print all of
the document.
Press ▲ or ▼ to select Change Paper, and
then press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough
paper for the print job, and then print.
then press the OK button.
Change the Paper Source of the printer driver,
or replace the roll with a roll that has enough
paper for the print job, and then print.
Press ▲ or ▼ and select Stop Printing or
press the Stop button to stop printing.
press the Stop button to stop printing.
This paper cannot be used as size is not supported.
This paper cannot be used as size is not supported.
Cause
Corrective Action
Paper that is too large for the printer has been loa-
ded.
ded.
Lift the Release Lever and load paper of the correct size.
Paper that is too small for the printer has been loa-
ded.
ded.
Lift the Release Lever and load paper of the correct size.
Paper has been loaded that is too small to print the
test pattern for printhead adjustment or nozzle
checking.
test pattern for printhead adjustment or nozzle
checking.
Lift the Release Lever and load unused paper A4/Letter (vertical) or larger. More
than one sheet may be required depending on the adjustment.
than one sheet may be required depending on the adjustment.
Roll printing is selected.
Roll printing is selected.
Cause
Corrective Action
You have attempted to print on a roll, but
no roll is loaded.
no roll is loaded.
Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll,
and then print.
and then print.
Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.
Roll printing is selected, but sheets are loaded.
Roll printing is selected, but sheets are loaded.
Cause
Corrective Action
A print job for rolls was received when a sheet is
loaded.
loaded.
Follow these steps to load and print on a roll.
1.
Press ▲ or ▼ to select Eject Paper, press the OK button, and remove the sheet.
2.
Load a new roll.
iPF8400SE
Insufficient paper for job
Error Message
Messages regarding paper
661