Руководство Пользователя для Xerox Document Centre ColorSeries 50
PROBLEM SOLVING
13–14
DOCUMENT CENTRE CS 50 USER GUIDE
2
3
4
5
6
7
13
Resolving Processor problems
Problem
Suggested Solution
Transparencies
Use transparencies with a painted or removable white stripe. Load them with
stripe down, as the lead edge of the sheet in Paper Tray 5.
stripe down, as the lead edge of the sheet in Paper Tray 5.
Load the transparencies by following the instructions in chapter 9, “Paper.”
Transparencies are too
oily
oily
• Make 5 blank sheet copies with the Full Color option on paper stock to purge
excess oil from system. Reload the transparencies in Paper Tray 5 and con-
tinue the copying job.
excess oil from system. Reload the transparencies in Paper Tray 5 and con-
tinue the copying job.
• Use the Transparency Separator option.
Refer to the Recommended Materials List and the Color Materials Usage
Guide for more information about transparencies.
Guide for more information about transparencies.
11 x 17 inch (A3) trans-
parencies jam when exit-
ing the copier/printer to
the Output Tray
parencies jam when exit-
ing the copier/printer to
the Output Tray
Remove each copy of 11 x 17 inch (A3) transparencies from the Output Tray
before subsequent copies exit the copier/printer.
before subsequent copies exit the copier/printer.
Transparencies stick
together after copying
together after copying
Select the Transparency Separator feature to eliminate the problem.
Multiple sheets feed from
the paper trays
the paper trays
Do not fill the paper trays above the MAX fill line indicator. Trays 1, 2, 3, and 4
hold approximately 550 sheets of 24-lb (90 gsm) paper.
hold approximately 550 sheets of 24-lb (90 gsm) paper.
Remove the paper from the tray and fan the sheets to separate the joined
sheets.
sheets.
Predrilled sheets may stick together at the holes. Remove the paper from the
tray and fan the sheets to separate the joined sheets.
tray and fan the sheets to separate the joined sheets.
Multiple sheets feed from
Paper Tray 5
Paper Tray 5
Paper and transparencies may stick together if environmental conditions are
too dry and cause excessive static. Increase the humidity level in the copier/
printer room to minimize static.
too dry and cause excessive static. Increase the humidity level in the copier/
printer room to minimize static.
Do not overload Paper Tray 5.
Gently fan transparencies to separate the sheets before you load them into
Paper Tray 5. If multiple sheet feeding continues, feed the transparencies one
at a time from Paper Tray 5.
Paper Tray 5. If multiple sheet feeding continues, feed the transparencies one
at a time from Paper Tray 5.
Sheets will not feed from
the Paper Tray 5
the Paper Tray 5
Ensure that the height of the stack does not exceed the MAX fill line.
Check that the paper guide is not too tight. The paper guide should be
adjusted to fit snug against the paper stack.
adjusted to fit snug against the paper stack.