Руководство По Установке для Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP)
16
Installing and Operating UBIC-V EIAs in the Cisco ONS 15454
78-16140-04
Install UBIC-V EIA Cables
Step 3
Use the flathead screwdriver to tighten the screw at the top left of the cable connector two to three turns
at 8 to 10 lbf-inch (9.2 to 11.5kgf-cm). Repeat this for the screw at the bottom right of the connector.
Alternate between the two screws until both are tight.
at 8 to 10 lbf-inch (9.2 to 11.5kgf-cm). Repeat this for the screw at the bottom right of the connector.
Alternate between the two screws until both are tight.
Step 4
Repeat Steps
for each cable you want to install, moving from the bottom row to the top row.
If you are installing a cable near cables that are already installed you may need to gently hold back the
surrounding cables.
surrounding cables.
shows a UBIC-V with cables installed in all connectors.
Figure 12
Fully Cabled UBIC-V
shows a partially populated UBIC-V.
115074
Front view
Side view