Руководство По Установке для Cisco Cisco 5760 Wireless LAN Controller

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Do not reach into a vacant slot when installing or removing a module. Exposed circuitry is an energy 
hazard. Statement 206

Only trained and qualified personnel should be allowed to install, replace, or service this equipment. 
Statement 1030

Turn off the power at its source. 

Remove the power cord from the power cord retainer.

Remove the power cord from the power connector.

Press the release latch at the right side of the power supply module inward and slide the power supply 
out. (

Do not leave the power-supply slot open for more than 90 seconds while the controller is operating.

This unit might have more than one power supply connection. All connections must be removed to 
de-energize the unit. Statement 1028

Insert the new power supply into the power-supply slot, and gently push it into the slot (

correctly inserted, the 350-W power supply (excluding the power cord retainer) are flush with the 
controller rear panel.

(Optional) Make a loop in the power cord and thread it through the power cord retainer (

345731