Руководство По Установке для Cisco Cisco TelePresence MX700
D14639.06 Video Systems Getting Started Guide (TC5.1) | 2012 FEBRUARY | © 2011-2012 Cisco Systems, Inc. All rights reserved.
www.cisco.com
26
GettinG started Guide
Web interface
Configuring IP
(when not set by a provisioning system)
Your video conference system supports both IP version 4
(IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the required
parameters.
If an IP address is already assigned to your system, you can
find the current IPv4 and/or IPv6 address on the System
Information page:
Go to the
Diagnostics
tab and select
System Information
.
The system's IP address is listed in the General
section.
1. Select IP version
Go to the
Configuration
tab and select
Advanced
Configuration
.
Open the
Network 1
settings from the left column. Select
which IP version to use in the
IPStack
drop down list.
2. Select automatic or manual IP assignment
For IPv4: Select
DHCP
or
Static
in the
Assignment
drop
down list.
For IPv6: Scroll down the page to the
For IPv6: Scroll down the page to the
IPv6
section and
select
Autoconf
or
Static
in the
Assignment
drop down
list.
3. Set the IP addresses
Set the remaining IP settings according to the table
below. The actions required depend on the IP version
(
IPStack
) and IP assignment method (
Assignment
) you
selected in the previous steps.
Assignment
IPStack
DHCP/Autoconf
Static
IPv4
The IP configuration is complete.
a. Under the heading
IPv4
; enter the
Address
,
Gateway
and
SubnetMask
in the
corresponding input fields. Click
ok
to save
the change.
b. Under the heading
DNS
, enter the DNS
server address in the
Server 1 Address
input
field. Click
ok
to save the change.
IPv6
a. Select
On
or
Off
in the
DHCPOptions
drop
down list according to your preference.
1
a. Select
On
or
Off
in the
DHCPOptions
drop
down list according to your preference.
1
b. Enter the system IP address in the
Address
input field and the gateway address in the
Gateway
input field. Click
ok
to save the
change.
1
DHCP Options:
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, are obtained automatically from the network.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, are obtained automatically from the network.
Back to task overview
User interfaces
Introduction
Configuration
Table of contents
Appendices
Configuration