Примечания к выпуску для Cisco Cisco Aironet 350 Wireless LAN Client Adapter
5
Release Notes for Cisco Aironet MS-DOS Drivers and Utilities for WLAN Client Cards
OL-1803-01
Loading a New Driver and Utilities
Additional variables defined in the following section can also be used. Follow these steps to install the
driver.
driver.
Step 1
Power on your computer.
Step 2
Extract the NDIS.EXE files to the directory containing the network files on your computer’s hard drive.
Step 3
Copy the PROTOCOL.INI file to the network directory or merge statements from the Cisco Aironet
supplied file into your existing PROTOCOL.INI file.
supplied file into your existing PROTOCOL.INI file.
Step 4
Modify the CONFIG.SYS file. After the line containing: Device = PROTMAN.DOS, add
Device = [drive:] [path] CSCNDIS2.DOS.
Device = [drive:] [path] CSCNDIS2.DOS.
Step 5
To modify the PC Card system parameters, edit the PROTOCOL.INI file in the network directory. For a
list of parameters which can be modified. See
list of parameters which can be modified. See
Step 6
Reboot your computer.
DOS Packet Driver Installation
The installation of this driver includes creating or editing a configuration file (CSCPKT.INI). This file
must contain the lines shown in
must contain the lines shown in
Additional variables defined in the following section can also be used.
The Wireless LAN Adapter can be installed in a MS-DOS environment by using MS-DOS IP stack
products such as FTP software.
products such as FTP software.
Follow these steps to install the driver.
Step 1
Power on your computer.
Step 2
Extract the PKT.EXE files to the directory containing the network files on your computer’s hard drive.
Step 3
Make sure that the CSCPKT.INI file is in the directory containing the Packet driver.
Step 4
If you would like to modify the PC Card system parameters, edit the CSCPKT.INI file. For a list of
parameters that can be modified, see
parameters that can be modified, see
Step 5
Load the driver by typing CSCPKT [-cinuw] <int_number> at the MS-DOS prompt (for example,
CSCPKT 0x65) and press Enter.
CSCPKT 0x65) and press Enter.
Note
<int_number> is an interrupt vector location in the range of 0x60 to 0x7F.
Table 3 Minimum CSCPKT.INI Driver Settings
Infrastructure Mode
Ad Hoc Mode
[CSCPKT]
[CSCPKT]
INFRASTRUCTURE = YES
If omitted, default is YES
If omitted, default is YES
INFRASTRUCTURE = NO
SSID = <your SSID>
SSID = <your SSID>
CHANNEL = <channel>