Руководство По Установке для Cisco Cisco ONS 15454 M12 Multiservice Transport Platform (MSTP)
7
Installing the TXP_MR_10E_C and TXP_MR_10E_L Cards in the Cisco ONS 15454 SONET/SDH
78-17338-01
TXP_MR_10E_C and TXP_MR_10E_L Card Description
Figure 1
TXP_MR_10E_C and TXP_MR_10E_L Faceplate and Block Diagram
Card Level Indicators
describes the three card-level LEDs on the TXP_MR_10E_C and TXP_MR_10E_L cards.
uP bus
Serial bus
uP
Flash
RAM
Optical
transceiver
134975
Framer/FEC/DWDM
processor
Client
interface
DWDM
trunk
(long range)
Optical
transceiver
Client interface
STM-64/OC-192
or 10GE (10GBASE-LR)
or 10G-FC (1200-SM-LL-L)
STM-64/OC-192
or 10GE (10GBASE-LR)
or 10G-FC (1200-SM-LL-L)
B
a
c
k
k
p
l
a
n
e
n
e
DWDM trunk
STM-64/OC-192
82 tunable channels (C-band) or
80 tunable channels (L-band) on
the 50-GHz ITU grid
STM-64/OC-192
82 tunable channels (C-band) or
80 tunable channels (L-band) on
the 50-GHz ITU grid
FAIL
ACT/STBY
SF
10E MR
TXP L
TXP L
TX
RX
RX
TX
FAIL
ACT/STBY
SF
10E MR
TXP C
TXP C
TX
RX
RX
TX
Table 3
TXP_MR_10E_C and TXP_MR_10E_L Card-Level Indicators
Card-Level LED
Description
Red FAIL LED
The red FAIL LED indicates that the card’s processor is not ready. This LED
is on during reset. The FAIL LED flashes during the boot process. Replace
the card if the red FAIL LED persists.
is on during reset. The FAIL LED flashes during the boot process. Replace
the card if the red FAIL LED persists.
ACT/STBY LED
Green (Active)
Amber (Standby)
If the ACT/STBY LED is green, the card is operational (one or both ports
active) and ready to carry traffic. If the ACT/STBY LED is amber, the card
is operational and in standby (protect) mode.
active) and ready to carry traffic. If the ACT/STBY LED is amber, the card
is operational and in standby (protect) mode.
Amber SF LED
The amber SF LED indicates a signal failure or condition such as LOS, LOF,
or high BERs on one or more of the card’s ports. The amber SF LED is also
on if the transmit and receive fibers are incorrectly connected. If the fibers
are properly connected and the link is working, the light turns off.
or high BERs on one or more of the card’s ports. The amber SF LED is also
on if the transmit and receive fibers are incorrectly connected. If the fibers
are properly connected and the link is working, the light turns off.