Примечания к выпуску для Cisco Cisco Evolved Programmable Network Manager 1.2
2
Cisco Evolved Programmable Network Manager 1.2 Maintenance Pack 6 (V. 1.2.600) Release Notes
Cisco EPN Manager 1.2. MP6 Content
Cisco EPN Manager 1.2. MP6 Content
MP6 consists of a device version update and fixes for issues that can impact ongoing optical network
operation using Cisco EPN Manager.
operation using Cisco EPN Manager.
The following issues have been resolved in MP6:
Install Cisco EPN Manager 1.2. MP6 (No High Availability)
These are the steps for installing MP6 on a standard deployment with no high availability (HA):
Make Sure You Are Starting with the Correct Installed Base (No HA)
Maintenance Pack 6 can only be installed on Cisco EPN Manager 1.2 MP5. In other words:
•
MP6 cannot be installed on Cisco EPN Manager 1.2 (without any maintenance packs).
•
MP6 cannot be installed on Cisco EPN Manager 1.2 that has other MPs installed but not MP5.
Perform these steps to make sure you have the correct installed base before installing MP6.
Step 1
Choose Administration > Licenses and Software Update > Software Update.
Step 2
If Maintenance Pack 6 is listed and its status is “Installed,” you can proceed with the MP6 installation
(go to
(go to
If MP5 is not listed, do not proceed with the MP6 installation. You must install MP5. Please refer to the
release notes
for MP5 for installation instructions.
Identifier
Symptom
CSCuz33056
Partial OCH-Trail UNI circuit discovered
CSCuz19605
EPNM cannot export an NE's configuration archive when SNMP
unreachable
unreachable
CSCuz38332
50% of NCS4Ks in Collection failure after SW non-ISSU and FPD
upgrades
upgrades
CSCuz48387
NCS 4K 6.0.2 Support
CSCuz44044
On OchTrail UNI EPNM must delete Head part first and then Tail part
CSCuy90139
ODU UNI CTC circuit deletion causes ODU Tunnel implicit flag removal
Step
Procedure
1.
2.
3.