Справочник Пользователя для Acer altos r510 mk2

41

Installing and Removing a Hard Disk 

Drive

Up to three hard drives of one of the following types can be installed, 
depending on the hard drive installation option used in your server 
chassis and the drives supported by your server board.

1

Three fixed SATA drives or three fixed SCSI drives if the fixed drive 
kit is installed.

2

Three hot-swap SATA drives if the SATA backplane is installed.

3

Three hot-swap SCSI drives if the SCSI backplane is installed.

NOTE: The Altos R510 does not support all hard drives. Contact 
your local Acer dealer for details of supported hardware.

Installing a Fixed SATA Hard Disk Drive

Use these instructions only if you have installed the fixed drive kit. 

CAUTION:

Fixed drives are NOT hot swappable. Before removing or 

replacing the drive, you must first take the server out of service, 
turn off all peripheral devices connected to the system, turn off 
the system by pressing the power button, and unplug the AC 
power cord from the system or wall outlet.

1

Observe the safety and ESD precautions at the beginning of this 
book. See 

“Safety Information.”

2

Power down the server and unplug all peripheral devices and the 
AC power cable. 

3

Remove the front bezel if it is installed. For instructions, see 

“Removing and Installing the Front Bezel.”

4

Remove the chassis cover. For instructions, see 

“Removing the 

Chassis Cover.”

5

Press the latch on the back of the fixed drive carrier and slide it out 
of the bay. See letter “A” in the figure below to identify the latch 
at the rear of the carrier.