Справочник Пользователя для Alcatel-Lucent speedtouch 500
312
PPPoE Commands
acname
The Access Concentrator name for a PPPoE connection.
Execute the pppoe ifscan command to see the names of available access
concentrators, if any.
Execute the pppoe ifscan command to see the names of available access
concentrators, if any.
OPTIONAL
servicename
The Service Name for a PPPoE connection.
Execute the pppoe ifscan command to see the available service names, if
any.
Execute the pppoe ifscan command to see the available service names, if
any.
OPTIONAL
pcomp
Try (on) or do not try (off) to negotiate PPPoE protocol compression
(LCP PCOMP). By default the negotiation is disabled (off).
(LCP PCOMP). By default the negotiation is disabled (off).
OPTIONAL
accomp
Try (on), do never try (off) or negotiate (negotiate) to negotiate PPPoE
address & control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, i.e.
the address field FF-03 should not be sent over ATM. Therefore by default
this parameter is enabled (on).
If the accomp parameter is set to 'negotiate', the local side of the PPPoE
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
address & control field compression (LCP ACCOMP).
In most cases, LCP ACCOMP should not be disabled nor negotiated, i.e.
the address field FF-03 should not be sent over ATM. Therefore by default
this parameter is enabled (on).
If the accomp parameter is set to 'negotiate', the local side of the PPPoE
connection demands to do ACCOMP and adapts itself to the result of this
negotiation.
OPTIONAL
trace
Enable (on) or disable (off) verbose console logging.
By default tracing is disabled (off).
By default tracing is disabled (off).
OPTIONAL
concentrator
The access concentrator is on this side of the PPPoE connection.
Choose between:
Choose between:
•
on: the PPPoE connection is terminated on the Access
Concentrator (here the SpeedTouch™ itself)
Concentrator (here the SpeedTouch™ itself)
•
off: the SpeedTouch™ is PPPoE client (default)
OPTIONAL
auth
Select the authentication protocol.
Choose between:
Choose between:
•
pap: Password Authentication Protocol (PAP) authentication will be
forced.
forced.
•
chap: Challenge Handshake Authentication Protocol (CHAP)
authentication will be forced.
authentication will be forced.
•
auto: CHAP authentication will be used. If CHAP authentication is
not successful, PAP authentication will be used instead.
Auto is the default setting.
not successful, PAP authentication will be used instead.
Auto is the default setting.
OPTIONAL
restart
Automatically restart the connection when Link Control Protocol (LCP)
link goes down (on) or do not restart automatically (off).
By default restart is disabled (off).
link goes down (on) or do not restart automatically (off).
By default restart is disabled (off).
OPTIONAL
retryinterval
A number between 0 and 65535 (seconds).
Represents the intermediate interval between two retries to establish the
connection on PPP level (LCP) (default=10).
Represents the intermediate interval between two retries to establish the
connection on PPP level (LCP) (default=10).
OPTIONAL
passive
Put the link in listening state in case LCP times out (on) or not (off).
This parameter allows to determine whether the link should be left open
to wait for incoming messages from the remote side after 10 unsuccessful
tries to establish the connection or not.
By default, the listening state is disabled.
This parameter allows to determine whether the link should be left open
to wait for incoming messages from the remote side after 10 unsuccessful
tries to establish the connection or not.
By default, the listening state is disabled.
OPTIONAL