Справочник Пользователя для Alliance Laundry Systems sc50

29

F232062

Note: Do not mount on wooden floors, 
above ground level, or over basements or 
crawlspaces. Installation must be “slab on 
grade” or equivalent.

A proper foundation is absolutely necessary 
for all models because of the high extract 
speed and the G-forces exerted.

Thoroughness of detail must be stressed with 
all foundation work to insure a stable unit 
installation, eliminating possibilities of 
excessive vibration during extract. 

The machine must be secured to a foundation 
or floor of adequate construction. The floor 
must be 3500 psi minimum reinforced 
concrete embedded in clean, compacted fill 
dirt. For 2-speed models, the floor must be at 
least 4 inches (102 mm) thick. For 3-speed 
and variable-speed models (except for the 
80-pound capacity model), the floor must be at 
least 6 inches (152 mm) thick. For 80-pound 
capacity models, the floor must be at least 9 
inches (229 mm) thick.

The machine must be anchored to a smooth 
level surface so that the entire base of the 
machine is supported and rests on the 
mounting surface. (Do not support the machine 
on only four points.) Anchor bolts for machine 
sizes up to the 50-pound capacity model must 
be a minimum of 5/8-inch diameter, grade 2. 
Anchor bolts for the 80-pound capacity model 
must be a minimum of 3/4-inch diameter, 
grade 2.

Care must be exercised in the design of the 
mounting base due to the force exerted by the 
machine during extract.

Static and dynamic loads on the floor or 
foundation are shown in the Cabinet 
Hardmount Floor Load Data tables in this 
subsection. These tables can be used as a 
reference when designing floors and 
foundations.

Ensure that the machine is installed on a 
level floor of sufficient strength and that the 
recommended clearances for inspection 
and maintenance are provided. Never allow 
the inspection and maintenance space to 
be blocked.

SW020