Справочник Пользователя для Alliance Laundry Systems sc50
31
Installation
F232062
Mechanical Installation
This subsection provides four specific methods
of mechanical installation. Follow the
procedure most appropriate for your machine.
of mechanical installation. Follow the
procedure most appropriate for your machine.
Note: Improper installation may void the
warranty. Consult the manufacturer or your
distributor before deviating from the
appropriate procedure.
warranty. Consult the manufacturer or your
distributor before deviating from the
appropriate procedure.
Expansion Bolt Installation
(2-Speed Models Only)
Note: Expansion bolts are not suitable
for 3-speed or variable-speed machine
installations. Expansion bolts should not be
used in single-machine concrete foundation
pad installations.
for 3-speed or variable-speed machine
installations. Expansion bolts should not be
used in single-machine concrete foundation
pad installations.
Use the following instructions and Figures
15 through 20 as a step-by-step guide
to installation of the expansion bolts.
15 through 20 as a step-by-step guide
to installation of the expansion bolts.
1. Verify that the floor is 3500 psi minimum
reinforced concrete embedded in clean,
compacted fill dirt and at least 4 inches
(102 mm) thick.
compacted fill dirt and at least 4 inches
(102 mm) thick.
2. Verify that the mounting surface is level
and even. If the mounting surface fails to
meet these requirements, the machine
must be installed using J-bolts and
machinery grout.
meet these requirements, the machine
must be installed using J-bolts and
machinery grout.
3. Use the base of the machine as a template
by positioning the machine in the desired
location and marking the pre-drilled
mounting holes on the floor. See
Figure 15.
location and marking the pre-drilled
mounting holes on the floor. See
Figure 15.
Figure 15
4. Set the drill depth gauge to 2-9/16 inches
(65 mm). See Figure 16.
Figure 16
5. Drill the holes to the set depth. See
Figure 17.
Figure 17
H025I
H026I
H027I