Справочник Пользователя для Lucent Technologies P333T
Chapter 4
Installation and Setup
Cajun P333T User’s Guide
21
Appropriate cables are available from your local supplier.
*1000BASE-LX over Multimode fiber requires a special Patch cord cable which you
can obtain from your local cable supplier.
can obtain from your local cable supplier.
Connecting to the Serial Port
Cajun P333T has one serial port on the front of the switch for connecting a
terminal, a terminal emulator, or a modem using the supplied adapter.
terminal, a terminal emulator, or a modem using the supplied adapter.
Note: Modem connection requires a modem adapter which is supplied by Lucent
upon request.
upon request.
The RJ-45 port on the front of the switch is labeled “Console”, and may be used to
configure the switch using the built-in Command Line Interface (CLI, Terminal
Emulation). In the future, this connector will also be used for out-of-band SNMP
management, via a modem.
configure the switch using the built-in Command Line Interface (CLI, Terminal
Emulation). In the future, this connector will also be used for out-of-band SNMP
management, via a modem.
The port settings are as follows:
•
Baud Rate - 9600 bps
•
Character Size - 8
•
Parity - None
•
Stop Bit - 1
•
Flow Control - None
•
We recommend using a VT-100 terminal to enable access to all CLI features.
The terminal connected to the serial port must be configured with the same
settings; this setting will work with any PC COM port over a DB9 to RJ45
connector.
settings; this setting will work with any PC COM port over a DB9 to RJ45
connector.
Table 4.3
Gigabit Ethernet Cabling
Gigabit Interface
Fiber Type
Diameter
(
(
µ
m)
Modal
Bandwidth
Bandwidth
Maximum
Distance (m)
Distance (m)
1000BASE-SX
MM
62.5
160
220
1000BASE-SX
MM
62.5
200
275
1000BASE-SX
MM
50
400
500
1000BASE-SX
MM
50
500
550
1000BASE-LX
MM
62.5
500
550
1000BASE-LX
MM
50
500
550
1000BASE-LX
SM
9
NA
5,000
1000BASE-SLX
SM
9
NA
10,000