Справочник Пользователя для Lennox elite epic-ck-lp

Скачать
Страница из 4
rEaD  aLL  ThE  STEpS  BEFOrE  STarTING  ThE  CONvErSION. 
INSTaLLEr NOTICE: ThESE INSTruCTIONS MuST BE LEFT wITh 
ThE appLIaNCE.
This kit contains components required to convert this appliance 
from using propane Gas to using Natural Gas as the only fuel. 
all of these components must be replaced in order for the unit to 
operate safely on Natural Gas. 
when  installing  gas  components  use  pipe  joint  compound  or 
Teflon tape on all pipe fittings before installing (ensure propane 
resistant compounds are used, do not use pipe joint compounds 
on flare fittings).
INSTaLLaTION INSTruCTIONS
TurN OFF ThE GaS SuppLy TO ThE appLIaNCE. 
Step 1. Using an 1/8” allen wrench, remove the control panel cover by 
removing the 4 button screws around the control panel (indicated 
by arrows in Figure 1)Do not disconnect any wires during this 
step.
remove regulator
diaphragm
Step 2. Remove the knob extensions on the gas control and flame height 
knobs by pulling them off.
Step 3. Using a Torx T20 or flat screwdriver, remove the Nova SIT LP 
Regulator (flame height knob) by removing the 3 screws sur-
rounding it (see Figures 2 and 3) . Be sure to also remove the 
LP regulator diaphragm (see Figures 2 and 4).
Step 4. Install the Nova SIT NG Regulator (included in this kit) using the 
3 new screws provided as shown in Figure 3
Diaphragm
Screws
regulator
pressure
regulator
remove 
These 
Components
Figure 4
Fill out & affix label from 
regulator kit to valve
Step 5. Replace the knob extensions on the gas control and flame height 
knobs.  Reinstall the control board panel using the 4 button screws 
removed during step 1.
Step 6. Using a 5/32” allen wrench, remove the 2 screws near the rear 
corners of the burner pan (see Figure 6).
Figure 1
Figure 2
Figure 3
Figure 5
Figure 6
Control panel
Burner pan
regulator screws are 
indicated by arrows
Control Board panel
Screws are indicated by arrows
Screws are indicated by arrows
regulator screws are 
indicated by arrows
NOTE: DIAGRAMS AND ILLUSTRATIONS ARE NOT TO SCALE.
2