Справочник Пользователя для Zebra 49834
Troubleshooting
Print Quality Problems
57518L-001 Rev. A
3/18/05
170PAX4 Maintenance Manual
111
Vertical image or
label drift
label drift
The print engine is using
noncontinuous labels but is
configured in continuous
mode.
noncontinuous labels but is
configured in continuous
mode.
Configure the print engine for non-continuous
and run calibration routine, if necessary.
and run calibration routine, if necessary.
Incorrectly positioned media
sensor.
sensor.
Ensure the media sensor is properly positioned
to read a single/consistent interlabel gap.
to read a single/consistent interlabel gap.
Improperly calibrated media
sensor.
sensor.
See
.
The platen roller is dirty.
Clean the platen roller.
Improper printhead pressure
settings (toggles).
settings (toggles).
Adjust the printhead pressure to ensure proper
functionality.
functionality.
Improperly loaded ribbon or
media.
media.
Verify that the ribbon and media are properly
loaded.
loaded.
Incompatible media.
Ensure that the interlabel gaps or notches are
2 to 4 mm and consistently placed. Media must
not exceed minimum specifications for mode of
operation.
2 to 4 mm and consistently placed. Media must
not exceed minimum specifications for mode of
operation.
The bar code printed
on a label does not
scan.
on a label does not
scan.
The bar code is not within
specifications because the print
is too light or too dark.
specifications because the print
is too light or too dark.
Perform the
the darkness or print speed settings as necessary.
Table 13 • Print Quality Problems (Continued)
Problem
Possible Cause
Recommended Solution