Справочник Пользователя для iceberg 20100

The BeverageMate™ has a
number of assembly steps
which, if done before the actual
assembly begins, will reduce
time and make the project much
easier. Please follow the steps
carefully.

Remove serving tray from slot
and set aside.

Step 1.
Turn Top upside down. Locate 8
pre-drilled holes. Insert threaded
end of Cam-Lock pins and tighten
into holes with screwdriver.

Turn Bottom upside down. Locate
4 pre-drilled holes in each corner.
Position caster plate over holes.
Insert and tighten screws through
each hole. Repeat steps for each
caster.

Step 3.
Turn Bottom right side up (on
casters). Locate 8 pre-drilled holes.
Insert threaded end of Cam-Lock pins
and tighten into holes with
screwdriver.

Step 4.
Find 2 sides of BeverageMateTM.
Find 2 hinge mounting brackets.
Locate 2 pre-drilled holes on each
side. Position brackets over
pre-drilled holes and using screws
secure tightly.

Step 5.
Find 2 door panels. Find 2 hinge
assemblies. Locate 2 pre-drilled
holes and hinge seat, on each door.
Insert hinge assembly into hinge seat
with hinge holes over pre-drilled
holes in door. Using screws secure
tightly. Holding by end, fold hinge

arm down.

Hinges arms are spring loaded,
fold down carefully.