Справочник Пользователя для iceberg 20100

Step 11.
Insert leveling screw in hinge
mounting bracket through hole in
hinge arm.

Step 12.
Using screwdriver, slightly tighten
screw to hold door in place. Repeat
procedure for all 4 hinges.

Step 13.
Close both doors and look at how
they line up. Using the leveling set
screw (front), loosen or tighten to
level the doors from side to side.

Step 14.
Using the rear set screw, loosen
and move the hinge in or out to
adjust the tightness of the door
against the cabinet. When doors are
properly adjusted, re-tighten screws.

Step 15.
Locate 2 pre-drilled holes on each
door. Position door handle on front
of door over holes. Using wood
screws, secure handles to doors.
IMPORTANT Re-insert serving
tray into slot under Beverage Mate
top.

Step 16.
Insert 8 shelf support pins into
pre-drilled holes. All 4 pins which
support each shelf should be level.

Step 17.
Turning each shelf at a slight angle
insert into cabinet and position on
shelf support pins. IMPORTANT If
shelf does not rest flat on pins raise
shelf, remove pins, reposition into
hole, and lower shelf.

Your BeverageMate™ cabinet is
complete and now ready for use.