Справочник Пользователя для GRAUPNER CO. LTD. 19001200

19 / 28

S5012_Alpha_110_jh_V1

Choose a free area for your first flight. Select first always the Atti-

tude mode because so the copter is easier to control and the 

throttle course is different in Rate mode. Take firstly confidence 

with the flight attitude of the Alpha 110Q. Proceed carefully and 

responsibly.

Initialization of the gyro
Once the model has been switched on, the gyro immediately 

becomes active but still needs to be initialized. To initialize the 

gyro, keep your model still when you switch it on. The calibra-

tion process can only be performed when the receiver is abso-

lutely still. After 3 seconds in still position you will hear beeps 

emitted by all motors. The signal tone can vary depending on 

the esc model. These "wiggles" signal that initialization has been 

successful and that calibration is complete. Always wait until the 

calibration process has finished before starting to fly the model. 

The motors will not start until the calibration is complete.

If the copter is used for long time (>1min) in Acro 3D mode the 

receiver can loose its position information and the copter can 

move itself out of control. Before switching back to Attitude 

mode, hover the copter for 30 s or land it in Rate mode, so that 

the receiver can reset the position.

The auto-flip function allows you to flip your copter in a very easy 

way. It is essential that you control in Attitude mode (function not 

allowed in Rate mode).
The auto-flip function must be controlled by 

channel 6. For this 

program a 2-way switch (e. g. SW1) in the transmitter control 

menu on channel 6 with the following values:
Auto-flip function on = Channel 6 > 110%

Auto-flip function off = Channel 6 < 110%
Activate the switch and within 5 sec move the nick or roll stick 

to more than 50% of its course, then the copter makes auton-

omously a flip in the selected direction. After the flip it is possible 
to have some little position movements (<10°).