Справочник Пользователя для Zebra Technologies Corporation RFID-Z4M-01

Basic Configuration

R4Mplus User Guide 

47

The Tear-Off position defines the position of the label on the tear-off bar. When working with 
non-continuous labels, the inter-label gap should be on the tear bar. This setting does not apply 
to continuous media.

4. Are you using continuous media?

• If yes, press PLUS (+) to move to the next option: 

PRINT MODE

. Continue with 

.

• If no, continue with 

Step 5

.

5. Does the inter-label gap line up on the tear bar?

• If yes, press PLUS (+) to move to the next option: 

PRINT MODE

. Continue with 

.

• If no, complete the following steps:

5.1. Press SELECT.
5.2. Press PLUS (+) to move the label forward or MINUS (–) to move the label 

backward. Repeat this until the label lines up correctly.

5.3. Press SELECT to accept the changes.
5.4. Press PLUS (+) to move to the next option.

PRINT MODE

 displays. Continue with 

.

When the wrong Print Mode is selected, the top of the label is not found by the printer. 
Examples of common problems include when the gaps between noncontinuous labels do not 
line up on the tear bar or when continuous media is not being cut at the right interval.

6. Do the labels line up or cut correctly?

If yes, press PLUS (+) to move to the next option: 

MEDIA TYPE

. Continue with 

.

If no, review the media and the printer options, then complete the following steps:

6.1. Press SELECT.
6.2. Press PLUS (+) or MINUS (–) to scroll through the setting options. Stop at the 

setting that matches your printer options (Tear-Off, Peel-Off, or Rewind).

6.3. Press SELECT to accept the change.
6.4. Press PLUS (+) to move to the next option.

MEDIA TYPE

 displays. Continue with 

.