Справочник Пользователя для B+B SmartWorx THINQ1
Quatech SDS User’s Manual
Configuring the SDS using a Web interface
Figure 43 - Home page screen
Figure 43 shows Quatech’s
Serial Device Server Home
Serial Device Server Home
page. From this screen, you
can:
can:
¾
Access network settings
¾
Change serial port settings
¾
Run diagnostics
¾
Perform admin functions
¾
Contact Quatech
This screen shows you the
hardware revision level, the
SDS product description, and
SDS product description, and
the software revision level.
Setting network parameters
Once you have made the initial network connection, you can maintain
and configure this connection using Quatech’s Web interface. Of course,
you can always go back and use the Installation Wizard to program the
settings for the SDS. Contact your network administrator if you are
settings for the SDS. Contact your network administrator if you are
unsure of any of these settings.
Note: If you inadvertently lose
contact with the SDS, use the
Installation Wizard to re-establish
contact.
contact with the SDS, use the
Installation Wizard to re-establish
contact.
Note: To setup for a Wireless
(Wi-Fi) SDS, you must first
connect to it using the wired
connect to it using the wired
Ethernet mode. See Enabling
Wi-Fi Device Servers on page
14 for details.
14 for details.
See Setting TCP/IP (LAN) and Wi-Fi (Wireless) parameters below or
see Setting SNMP parameters on page 49.
see Setting SNMP parameters on page 49.
Setting TCP/IP (LAN) and Wi-Fi (Wireless) parameters
Step
Procedure
Description
Preliminary
Step
Click on Network in the selection bar.
The Network Setup screen shown on
the following page displays.
March 2005
940-0183-151
Page 45