Справочник Пользователя для Microwave Radio Communications LLC STATXU064T1CK
Routine Operation
3-14
STRATA TX Operator’s Guide/Tech Ref Manual
5.
The normal power-up sequence is as follows:
-
The Status LED above the PWR switch should
illuminate and should change colors from red, to
green, to amber, and finally remain green.
illuminate and should change colors from red, to
green, to amber, and finally remain green.
-
The alphanumeric display should light up and quickly
display a self-test screen, then the version of the
installed firmware, and finally the Main Screen.
Some typical screens are shown in
display a self-test screen, then the version of the
installed firmware, and finally the Main Screen.
Some typical screens are shown in
. The
exact screens will vary depending on installed
hardware.
hardware.
-
The TCU will typically power up using the last settings
in use when power was turned off.
in use when power was turned off.
-
If the TCU does not power up normally, refer to the
.
Figure 3-10: Typical TCU Power Up Screens - Single TCU
Power Down
1.
Set the TCU PWR switch to 0 (off).
2.
If the TCU is powered from the optional ACU, set the
ACU power switch to 0 (off).
ACU power switch to 0 (off).
STRATA TX
V X.X.X
Preset 1
0.00W
Radio Version
Main Screen
If the TCU is powered from a source other than an
ACU, turn that power source off.
ACU, turn that power source off.
3.3.5
Single TXU Power up and Power Down
If your STRATA TX System consists of a single TXU, perform the
following steps:
following steps:
CAUTION
To avoid possible damage, turn off DC
Power on the coax before connecting any
test equipment.
Power on the coax before connecting any
test equipment.
Power Up
1.
Verify the power cable is properly connected to the
TXU front panel POWER connector.
TXU front panel POWER connector.
2.
Verify all coaxial cables and connectors have been
properly connected.
properly connected.
3.
Connect the TXU to DC power of the correct voltage
and polarity.
and polarity.
If you are unsure of the power requirements or the
connections, refer to the
connections, refer to the
“Installation” Chapter on
page 6-1
(Part of the STRATA TX System Technical
Reference Manual only).
If the TXU is powered from the optional STRATA ACU,
connect the ACU input to AC power and verify the
TXU power cable is connected to the ACU DC
OUTPUT connector. Set the ACU power switch to I
(on) and verify the ACU power LED is on.
connect the ACU input to AC power and verify the
TXU power cable is connected to the ACU DC
OUTPUT connector. Set the ACU power switch to I
(on) and verify the ACU power LED is on.