Справочник Пользователя для UTC Fire & Security B.V. NX1700E
NX-1700E Card Reader
6
Scan: To
“present” or
pass a card or
FOB within
sensing range
of the card
reader module.
“present” or
pass a card or
FOB within
sensing range
of the card
reader module.
V.
ADDRESSING
Once the reader is wired into the system, the module needs to be addressed. Unlike most
NetworX expanders, the address of any particular reader is determined by itself after
installation
NetworX expanders, the address of any particular reader is determined by itself after
installation
is
complete.
Follow
the
procedures
outlined
under
the
section
“PROGRAMMING”. When prompted to enter the module device number, a card must be
scanned at the reader to initiate addressing (one short beep). When completed (1-2
seconds), the reader will beep back its address (long beeps):
scanned at the reader to initiate addressing (one short beep). When completed (1-2
seconds), the reader will beep back its address (long beeps):
Table V-1
Beeps
Address
Beeps
Address
1
113
9
121
2
114
10
122
3
115
11
123
4
116
12
124
5
117
13
125
6
118
14
126
7
119
15
127
8
120
VI.
PROGRAMMING
A. USING THE LED KEYPAD
ACTION
RESULT
E
NTERING THE
P
ROGRAM
M
ODE
Enters the Program Mode.
Stay, Chime, Exit, Bypass & Cancel LEDS will flash.
[
Go
To
Program
Code
]
Factory Default is
If the "Go To Program Code" is valid, the "Service"
LED will flash and the 5 function LEDs will illuminate
steady. You are now in the Program Mode and ready
to select the module address.
LED will flash and the 5 function LEDs will illuminate
steady. You are now in the Program Mode and ready
to select the module address.
E
NTERING THE
M
ODULE
A
DDRESS
Scan a card.
The card reader will address itself.
#
(example only)
Enters the module address. Refer to Table V-1 on
page 6 for the address assigned by the card reader
module itself.
page 6 for the address assigned by the card reader
module itself.
The Armed LED will illuminate while it is waiting for a
programming location to be entered.
programming location to be entered.