Справочник Пользователя для CONTELA INC. CHAMOMILE-A1
Installation manual for LoRa Gateway
8(12)
is off), then apply power. (It takes about 20 ~ 30 seconds)
(2) In case the red LED flashes repeatedly
Through G-EMS, check the IP address of Network Server is registered in LoRa
Gateway.
Check if the LoRa gateway is registered as a LoRa gateway that can be
interworked to the Network Server.
If the current state continues after checking all above, check with the local NOC
for the circuit configuration status.
(3) In case the orange LED flashes repeatedly
Check if MMC command execution from G-EMS to LoRa Gateway is working.
In case MMC command from G-EMS is executed
In case MMC command from G-EMS is executed
Check if the G-EMS address registered in LoRa Gateway is correct.
Check if the Gateway’s request is processed normally on the G-EMS.
Check if the Gateway’s request is processed normally on the G-EMS.
In case MMC command from G-EMS is not executed
Check the configuration of the line to make sure that there is no problem in
network connection with G-EMS.
1.2 Hardware Installation
Check lists for LoRa Gateway installation
A. Check the installation materials of LoRa Gateway
A. Check the installation materials of LoRa Gateway
Check the contents of LoRa Gateway (AC input cable connector etc.)
Identification of facility materials (main installation bolt/nut, facility structure, etc.)
Identification of facility materials (main installation bolt/nut, facility structure, etc.)
B. Check the external condition of LoRa Gateway before installation.
Make sure that the tightening screws of the LoRa Gateway are tightened and there is no
problem with the waterproof structure.
Make sure that there is no apparent problem during the movement of each external port.
C. Check the installation direction of the LoRa Gateway. (Ports are always downward)
LoRa Gateway should be installed in a position where the upper side of the LoRa
Gateway is open to see the sky so that the GPS antenna can receive the satellite
signals smoothly with the built-in GPS antenna.
Installation of LoRa Gateway
Check that all the installation materials of LoRa Gateway are prepared.
The following figure is an example of installing a pole, and it can be installed using a U-bolt
(or pole mounting device, pole fixing band, etc.) as shown.