Справочник Пользователя для Sonatest AP SONWP2
Copyright © 2015 Sonatest Limited - 2015-03-16
17
Connecting the WP2
5 Connecting the WP2
This section presents the connections between the Sonatest WP2 wheel probe to Sonatest test instruments and
instruments from other manufacturers.
instruments from other manufacturers.
The Sonatest test instruments include:
• veo
• Prisma
• RapidScan2
• Prisma
• RapidScan2
5.1 Connecting the WP2 to Sonatest Test Instruments
To connect the WP2 to the veo, the Prisma, and the RapidScan2, connect the wheel-probe side of the cable to the WP2
and connect the instrument side of the cable to the test instrument.
and connect the instrument side of the cable to the test instrument.
To connect the cable to the WP2:
1 Connect the phased array connector to the Samtec connector and fasten it using the thumbscrews.
2 Connect the 10-pin Lemo to the Encoder/GPIO connector located next to the Samtec connector.
2 Connect the 10-pin Lemo to the Encoder/GPIO connector located next to the Samtec connector.
Figure 5-1 WP2 connectors
To connect the cable to the veo:
1 Unscrew the protective cap on the right side of the instrument and place it on the back of the unit (over the CE
markings).
2 Connect the phased array connector to the Samtec connector and secure it with the hand screws.
Phased array connector (Samtec)
Connector thumb screws
Encoder/GPIO connector (Lemo)