Справочник Пользователя для Intrinsyc Technologies Corporation ITCOQ410S
Intrinsyc Open-Q™ 410 (APQ8016) SOM Module Certification Technical Note 16: OEM Integrator Guide
Rev. 1.1
6
Copyright Intrinsyc Technologies Corporation
7. SIMULTANEOUS TRANSMISSION WITH OTHER INTEGRATED
OR PLUG-IN RADIOS
The FCC and IC impose conditions and limitations when additional radio(s) are co-located
in the same host system as the Module with capability to transmit simultaneously. Co-
locating other radios such as an integrated or plug in Wireless WAN/cellular radio with the
Module requires additional evaluation and possibly submission for authorization from the
FCC and IC.
Because the rules are highly dependent on the characteristics of the particular radios that are
co-located and simultaneously transmitting, the OEM integrator should seek guidance from
a knowledgeable test lab or consultant to determine if additional testing and certification is
required. In this case, failure to evaluate and follow the required FCC and IC procedures will
invalidate the FCC and IC certifications of the Module and end system.
in the same host system as the Module with capability to transmit simultaneously. Co-
locating other radios such as an integrated or plug in Wireless WAN/cellular radio with the
Module requires additional evaluation and possibly submission for authorization from the
FCC and IC.
Because the rules are highly dependent on the characteristics of the particular radios that are
co-located and simultaneously transmitting, the OEM integrator should seek guidance from
a knowledgeable test lab or consultant to determine if additional testing and certification is
required. In this case, failure to evaluate and follow the required FCC and IC procedures will
invalidate the FCC and IC certifications of the Module and end system.
8. MODULE MAY NOT BE INSTALLED BY END USERS
FCC and IC rules require this Module to be installed in host systems at the factory by the
OEM integrator. Thus, end users of the system may not install the Module. Therefore, the
host product user instructions must not advise the end user on how to access or remove the
Module. Additional FCC authorization/filing is needed to allow end user installation of the
radio modules.
If modules are provided to the end users for installation in the host, a two-way
authentication protocol is required to limit the module to operate only with the authorized
host system.
OEM integrator. Thus, end users of the system may not install the Module. Therefore, the
host product user instructions must not advise the end user on how to access or remove the
Module. Additional FCC authorization/filing is needed to allow end user installation of the
radio modules.
If modules are provided to the end users for installation in the host, a two-way
authentication protocol is required to limit the module to operate only with the authorized
host system.
9. REQUIRED LABELING ON THE OUTSIDE OF THE HOST
9.1 FCC Labeling Requirements on the Outside of the Host
The FCC requires a label on the outside of the host system visible to the end user. Example
wording is:
Contains:
FCC ID: 2AFDI-ITCOQ410S
IC: 9049A-ITCOQ410S
FCC ID: 2AFDI-ITCOQ410S
IC: 9049A-ITCOQ410S