Справочник Пользователя для Intrinsyc Technologies Corporation ITCOQ410S
Intrinsyc Open-Q™ 410 (APQ8016) SOM Module Certification Technical Note 16: OEM Integrator Guide
Rev. 1.1
7
Copyright Intrinsyc Technologies Corporation
The FCC requires a logo signifying emission compliance on the outside of the host system.
The OEM integrator is responsible to perform FCC Part 15 Class B digital emissions testing
on the end system with the radio Module installed. The FCC logo below should not be
affixed unless the OEM integrator has obtained the necessary Part 15 approval, e.g., self-
declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of
certification issued by a TCB, the FCC ID number shown on the grant should be used on the
label instead of the FCC logo below.
The OEM integrator is responsible to perform FCC Part 15 Class B digital emissions testing
on the end system with the radio Module installed. The FCC logo below should not be
affixed unless the OEM integrator has obtained the necessary Part 15 approval, e.g., self-
declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of
certification issued by a TCB, the FCC ID number shown on the grant should be used on the
label instead of the FCC logo below.
Also see
A certified modular has the option to use a permanently affixed label, or an electronic label
(Refer to FCC KDB 784748 D02 e labeling for e-labelling guidance). All modules without
an integrated display on the module must be labelled with a module’s FCC ID - Section
2.926.
9.2 Industry Canada Labeling Requirements on the Outside of the Host
End Product Labeling
The final end product must be labeled in a visible area with the following for the
Open-Q
TM
410 SOM: Contains IC: 9049A-ITCOQ410S.
Plaque signalétique du produit final
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante:
Open-Q
TM
410 SOM: Contient des IC: 9049A-ITCOQ410S.