Справочник Пользователя для Hitachi RAC-25FXA RAC25FXA
Модели
RAC25FXA
10-6
CAUTION
•
The rubber strap used for fixing the insulator should
not be tied with great force. Otherwise, this will
damage the heat insulation and causes water
condensation.
not be tied with great force. Otherwise, this will
damage the heat insulation and causes water
condensation.
The Connection of Refrigerating Pipe during
the Installation of Indoor unit
Preparation to Install Refrigerating Pipes
•
The refrigerating pipes and connecting cord
transform and are attached.
transform and are attached.
•
The end of the refrigerating pipes are at locations
marked with “
marked with “
▼” symbol
CAUTION
•
Please fix in the plastic core after flaring to avoid
plastic chips entering the pipes.
plastic chips entering the pipes.
Installation
• Hang the Indoor unit onto the
hanger. Use the temporary stand
at the back of the Indoor unit to
push its lower part 15cm
forwards.
at the back of the Indoor unit to
push its lower part 15cm
forwards.
• Place the drain hose through the
hole on the wall
• Wrap the refrigerating pipes with
insulation pipe after connecting
refrigerating pipe.
refrigerating pipe.
• Connect the connecting cord after
removing electrical cover.(Refer
to Chapter13 Electrical Wiring)
to Chapter13 Electrical Wiring)
• After adjustment, the connecting
cord and refrigerating pipes are
placed into the space available
under the Indoor unit.
placed into the space available
under the Indoor unit.
• The projection of Indoor Unit must
hook to the hanger
Installation of drain hose
CAUTION
•
Be sure that the drain hose is not loosely
connected or bend.
connected or bend.
•
You are free to choose the side (left or right) for
the installation of drain hose. Please ensure the
smooth flow of condensed water of the Indoor unit
during installation. (Carelessness may result in
water leakage.)
the installation of drain hose. Please ensure the
smooth flow of condensed water of the Indoor unit
during installation. (Carelessness may result in
water leakage.)
Holder
Insulation pipe (must be wrapped
with vinyl tape at every 120mm
Pipe
Rubber strap tied with great force
Protection
pipe
Drain hose
Connecting cord
Connected section
Holder
Pull this to the front
during the connection
of refrigerating pipes
to ease task
Heat insulation pipe
Connecting
cord
Refrigerating pipe
Temporary stand
About 15cm
Projection
Bending
upwards
Condensed
water pond
Ditch
Condensed
water pond
Below
5mm
Please bend at a
small radius to form
an arc
0.65m