Техническая Спецификация для STMicroelectronics Evaluation board for A5970AD EVALA5970AD EVALA5970AD
Модели
EVALA5970AD
Functional description
A5970AD
14/42
DocID14661 Rev 5
5.7 Inhibit
function
The inhibit feature is used to put the device in standby mode. With the INH pin higher than
2.2 V the device is disabled and the power consumption is reduced to less than 100 µA.
With the INH pin lower than 0.8 V, the device is enabled. If the INH pin is left floating, an
internal pull up ensures that the voltage at the pin reaches the inhibit threshold and the
device is disabled. The pin is also V
2.2 V the device is disabled and the power consumption is reduced to less than 100 µA.
With the INH pin lower than 0.8 V, the device is enabled. If the INH pin is left floating, an
internal pull up ensures that the voltage at the pin reaches the inhibit threshold and the
device is disabled. The pin is also V
CC
compatible.
5.8 Thermal
shutdown
The shutdown block generates a signal that turns OFF the power stage if the temperature of
the chip goes higher than a fixed internal threshold (150 ± 10 °C). The sensing element of
the chip is very close to the PDMOS area, ensuring fast and accurate temperature
detection. A hysteresis of approximately 20 °C keeps the device from turning ON and OFF
continuously.
the chip goes higher than a fixed internal threshold (150 ± 10 °C). The sensing element of
the chip is very close to the PDMOS area, ensuring fast and accurate temperature
detection. A hysteresis of approximately 20 °C keeps the device from turning ON and OFF
continuously.