Справочник Пользователя для Brother 884-639

20

Attach zipper foot.

1

See “Changing Presser Feet 

 

✽

(Zipper Foot)” on page 17.
Turn the hand wheel towards you 

2

to lower the needle and adjust 
the position of the foot relative to 
the needle using the adjustment 
screw to slide the foot from left 
to right.

Secure the zipper with basting 

5

and sew along the mark.

CAUTION

Make sure the needle does not 
strike the metal part of the zipper 
when sewing. The needle may 
break and cause injury.

Line up the folded hem on the 

6

opposite side with the stitches.

Line up zipper to the section of 

3

fabric it will be attached to, and 
mark the base of the opening 
on the fabric. It should be set 
approximately 0.5 cm below zip 
stop. Sew from below the base 
of the opening.

Divide the seam margin. Fold 

4

the seam margin with the 
overlap of the zipper position 
facing down 0.2 cm on the 
outside of the mark.

A

0.5 cm

Slide

Base of 
Opening

Stop

0.2 cm

Change position of zipper foot.

7

Turn the hand wheel to lower the 

8

needle and position the presser 
foot. 

With the fabric right side up, 

9

baste the zipper onto the fabric, 
then sew the edge of the basting.

Reinforce base of opening by 

 

✽

sewing over it twice.
If the zipper slide gets in the 

 

✽

way, lower the needle all the way 
through the fabric, lift the foot, and 
move the slider out of the way.

B

CAUTION

Make sure the power to the machine is off before changing feet.

•

When attaching zippers to stretch fabrics, use the pin feed method and 

•

adjust foot pressure accordingly.
The zipper foot can also be used as a guide when attaching piping to 

•

fabric.