Справочник Пользователя для Digidesign Control 24

All LED Test Mode

All LED mode, when engaged, checks for proper 
lighting of all LEDs on the control surface by 
turning all LEDs on. 

When All LED test mode is engaged:

• The encoder switch LED located below the 

scribble strip which shows “All” will light 
solid indicating that this is the chosen test 
mode.

• All other LED test menu items shown on the 

scribble strips as well as their associated flash-
ing encoder switch LEDs, will remain visible 
in this test mode. This allows you to select an-
other LED test mode without the need to first 
“Exit” this mode.

• Press the flashing encoder switch located be-

low the scribble strip showing another test 
mode to simultaneously disengage the all LED 
test mode and enter the newly selected mode. 
The encoder switch LED for the new choice 
will light solid while the other choices flash.

• When finished, press EXIT.

Display Test Page

The Display test mode allows you to check that 
the displays (scribble strips, meters etc.) on the 
surface are functioning properly.

To enter Display test page:

1  

Press the flashing encoder switch below the la-

bel “Display.” The text label “Display” will be 
displayed in the dual 4-character scribble strip 
displays in the CHANNEL BAR and the channel 
scribble strips. 

The scribble strips located to the right of the dis-
play that shows “Exit” will be left blank. Since 
none of the choices are shown as a “default” se-
lection as is the case in other UTILITY menus, all 
encoder switch LEDs below each menu item will 
flash.

2  

Press the flashing encoder switch located be-

low the menu item of choice to enter the display 
test mode desired.

3  

When finished, press EXIT.

Meter Test Mode

Meter test mode will continually cycle through 
a series of automated tests which check the LEDs 
on each meter (fader and master section) on the 
meter bridge of Control|24. 

When “meters” display test mode is engaged:

• The encoder switch LED located below the 

scribble strip which shows “Mtrs” will light 
solid indicating that this is the chosen test 
mode.

• All other display test menu items shown on 

the scribble strips as well as their associated 
flashing encoder switch LEDs, will remain vis-
ible in this test mode. This allows you to select 
another display test mode without the need 
to first “Exit” this mode.

• Press the flashing encoder switch located be-

low the scribble strip showing another test 
mode to simultaneously disengage the meters 
test mode and enter the newly selected mode. 
The encoder switch LED for the new choice 
will light solid while the other choices flash.

• When finished, press EXIT.