Инструкции Пользователя для Garmin Vector S

Read all instructions carefully before installing and using the 

Vector system. Improper use could result in serious injury.
See the Important Safety and Product Information guide in the 

product box for product warnings and other important 

information.

Go to 

 for the latest information 

including bike compatibility, software updates, and video 

tutorials.

Thank you for your Vector or Vector S purchase. This manual 

covers both Vector systems.
Vector was designed for cyclists, by cyclists, to provide an 

outstanding experience of owning a precision power 

measurement system for your bike.
Vector is simple, accurate, and easy to use.
For software updates, video tutorials, and everything you need 

to get years of service out of your Vector, go to 

Now it's time to put the power under your feet and get out there 

and ride.

Install the Vector components (

).

Install the shoe cleats (

).

Pair Vector with your Edge

®

 device (

).

Go for a ride (

).

View your history (

).

Send your history to your computer (

).

• 15 mm crowfoot adapter for torque wrench
• 2.5 mm hex key

• 15 mm pedal wrench
• Bike grease
• 3 mm hex key
• 4 mm hex key

The installation steps for the Vector and Vector S systems are 

very similar. Procedures that are specific to the Vector S system 

are noted.

Confirm the compatibility of your bike at 

.

Find the sensor ID that is engraved on the spindle, and write 

it down.

Remove the existing pedals.

Clean the threads, and remove old grease.

Before you can install the right pedal, you must determine 

bicycle chain clearance.

Move your bike chain to the largest chain ring and the 

smallest cassette gear.
The bike chain should be in the outermost position to 

determine proper clearance between the pedal pod cable and 

the chain.
NOTE: There must be at least 5 mm clearance 

À

 between 

the chain and the crank arm.

This procedure is for the Vector system. For the Vector S 

NOTE: The left and right pedal pods are the same.

Install the left pedal first.

Apply a thin layer of grease on the pedal spindle threads 

À

.

Insert the spindle into the crank arm 

Á

.

Hand tighten the spindle.
NOTE: The left pedal spindle has a left-handed (reverse) 

thread.

Use the pedal wrench to tighten the spindle.
NOTE: Garmin

®

 recommends torque of 25 to 30 lbf-ft. (34 to 

40 N-m).

Clean all excess grease from the spindle using a clean cloth 

and soapy water or isopropyl alcohol.

Place the pedal pod 

Â

 on the spindle.

NOTE: You must carefully bend the cable 

Ã

 out of the way. 

The pedal pod should be flat against the crank arm.
TIP: Power and cadence calculations are not impacted by the 

orientation of the pedal pod. Garmin recommends placing the 

pedal pod on the leading edge of the crank. When the crank 

is in the forward position, the pedal pod should be pointing 

downward.

Firmly plug the cable into the spindle.

Insert the screw 

Ä

 into the pedal pod, and use the 2.5 mm 

hex key to tighten the screw.

Rotate the crank arm to check for clearance.
The pedal pod should not interfere with any part of the bike.

Repeat steps 2 through 10 to install the right pedal and pedal 

pod.
NOTE: If the pedal pod cable rubs the chain, you can add 

one or two washers between the spindle and the crank arm 

to increase clearance. Do not use more than two washers.

Introduction

1