Справочник Пользователя для Memorex Tek Partner Universal Remote Control

 

UNIVERSAL REMOTE CONTROL 

USER’S MANUAL

 

 

Congratulations! Your TEK PARTNER

TM

 Universal Remote Control is a state-of-the-art device which 

integrates many different infra-red remote controls. The TEK PARTNER

TM

 is pre-programmed at the 

factory, but you will need to enter a Device Code for each device to complete the program. Simply enter 
correct device codes for your equipment and your TEK PARTNER

TM

 is ready to use! A Device Code List 

is included in this User’s Manual. The TEK PARTNER

TM

 replaces up to 4 separate remote controls to 

operate your infra-red controlled televisions (TVs), video cassette recorders (VCRs), and cable boxes 
(CBLs). 

HOW TO INSTALL THE BATTERIES 

Your TEK PARTNER

TM

 requires 4 fresh  AA-size batteries (alkaline batteries recommended).  

1.  Remove the battery cover on the back of your TEK PARTNER

TM

.  

2.  Observe the polarity of the batteries and the "+/-" marks inside the battery compartment.  
3.  Insert the batteries.  
4.  Push the battery cover back in place.  

NOTE: 

When all batteries are disconnected, the TEK PARTNER

TM

 retains its setting only for 15 minutes. Should 

you fail to replace new batteries in time, use a stylus or the tip of a pen to reset the unit. The reset button is 
located inside the battery compartment. 

You may now have to re-program your TEK PARTNER

TM

. See SETTING UP YOUR TEK PARTNER

TM

 

section.  

MAIN FEATURES  

 

There are 4 Device Modes (TV, VCR, CBL, & AUX) in your TEK PARTNER

TM

. You may setup the TEK 

PARTNER

TM

 by the following code entering or searching instructions. 

Setup by entering DEVICE CODE 

Referring to the DEVICE CODE LIST, look up the 3-digit DEVICE CODE which corresponds to the 
brands and models of your video equipment. If there is more than one DEVICE CODE listed under your 
brand, try the first code with the following instructions: 

For example, entering your TV’s code: