Справочник Пользователя для Memorex Tek Partner Universal Remote Control

NOTES: 

 TV, VCR, and CBL Device Codes can be searched and locked into "CBL" & "AUX" modes. Simply 

press "CBL" or "AUX" Device Mode Button in step 2 and enter an appropriate Magic Search Code to start 
searching. 

 Each time you press the "VOL+" button, the TEK PARTNER

TM

  will skip to the next code. Then press 

the "PWR" button to send out a POWER signal trying to turn off your device. 

 If you failed to stop pressing "VOL+" in time when your device has been turned off, turn on your device 

again immediately. Before the indicator goes out, press "VOL-" on the TEK PARTNER

TM

 to skip 

backward. Repeat step 4 above and lock in the code. 

 If the power on/off function of your device is not infra-red controlled, you need to follow steps 1 thru 3 

above and start searching: Press "VOL+" and another important function button alternately until your 
device responds to the expected function, press the same device mode button again to lock in the code. e.g. 
Press "VOL+" & "1 " alternately, or; Press "VOL+" & "PLAY" alternately until the device responds. 

NORMAL OPERATION 

Once you have set up the TEK PARTNER

TM

 for your equipment, it works like your original remote 

controls. To operate, just aim it at your equipment, press an appropriate Device Mode Button and then 
command the desired function by pressing a corresponding button on the TEK PARTNER

TM

. The indicator 

flashes during signal transmission and as confirmation of button touch. At your button touch, your TEK 
PARTNER

TM

 illuminates the keypad for 4 seconds. You may see the keypad clearly even when you are 

operating your equipment in a dimly lit area. 

PUNCH THROUGH 

Punch through allows you to operate your TV’s volume and mute functions and your VCR’s 6 tape 
management functions without having to switch the device modes repeatedly even when your TEK 
PARTNER

TM

 is in other operating modes. 

MAINTENANCE  

1.  Do not expose your TEK PARTNER

TM

 to direct sunlight, high temperature, mechanical shock, or 

liquids.  

2.  Do not use old and new batteries together as old batteries tend to leak.  
3.  Do not use corrosive or abrasive cleansers on your TEK PARTNER

TM

.  

4.  Keep the unit dust free by wiping it with a soft, dry cloth.  
5.  Do not disassemble your TEK PARTNER

TM

, it contains no user-serviceable parts.  

Q. My TEK PARTNER

TM

 does not work at all! 

A. If your device’s main switch is turned off, the TEK PARTNER

TM

 can not operate the device. 

A. Check whether batteries are in good condition, inserted properly, and are in correct +/- polarity. See 
HOW TO INSTALL THE BATTERIES.