Справочник Пользователя для Mitsubishi Electronics C64T

 

76 

 

2054 clpush  Current limit 

(%) 

Set up the current limit value for the initial setting when 
detecting an absolute position with a dog-less system. 
The setup value is the ratio of the current limit value to 
the rated value. 

0 to 100 (%) 

2055  pushf 

Push speed 

Set the feedrate for the automatic initial setting during 
stopper method. 

1 to 999 (mm/min)

2056  aproch  Approach 

Set the approach distance for the automatic initial 
setting in the stopper method. 
Approach distance:  After pushing onto the machine 

stopper once‚ the tool returns this 
distance‚ and then pushes again.  

When set to 0‚ the reference point coordinates set in 
"#2037 G53ofs" will be used as the approach start 
position. 

0 to 999.999 (mm)

2057 nrefp 

Near zero 
point + 

Set the width where the near-reference-point signal is 
output. (Positive direction width)  
When set to 0‚ the width is equivalent to the grid width 
setting. 

0 to 32.767 (mm) 

2058 nrefn 

Near zero 

point 

− 

Set the width where the near-reference-point signal is 
output. (Negative direction width) 
When set to 0‚ the width is equivalent to the grid width 
setting. 

0 to 32.767 (mm) 

2059 zerbas  Select zero 

point 
parameter 
and 
reference 
point 

Specify the position to be the zero point coordinate 
during absolute position initial setting.  

0:  Machine stopper position in machine stopper 

method. 
Marked point in marked point alignment method. 

1:  On the grid point just before machine stopper in 

machine stopper. 
On the grid point just before the marked point in 
marked point alignment method. 

0/1