Справочник Пользователя для Mitsubishi Electronics #NAME?
5
- 15
5.3 Extension Safety Relay Module
5.3.1 Start-up procedures
5.3.1 Start-up procedures
5
SETTINGS AND PROCEDURES BEFORE
OPERATION
5.3
Extension Safety Relay Module
5.3.1
Start-up procedures
Figure 5.10 shows start-up procedures for the extension safety relay module.
Figure 5.10 Start-up procedures (1/2)
Yes
No
Start
Connect a safety circuit part
terminating connector to the last
module.
terminating connector to the last
module.
Mount a module on a DIN rail or
control panel.
control panel.
Connect safety circuit part extension
cable to the extension connector on
the front of the module (IN side).
cable to the extension connector on
the front of the module (IN side).
Connect more
extension modules?
Set start-up mode with start-up mode
setting switch.
setting switch.
Set the terminating resistor switch
for extension communication.
for extension communication.
Set the station number of extension
module communication.
module communication.
Connect the monitor part (EA, EB,
EG, EP) with shielded cable.
EG, EP) with shielded cable.
(To next page)