Dynatech PN 106082: 115v 用户手册
ITW Dynatec c. 1999
Page 3 - 1
TPC-2 TIMER Manual #50-05
Revised 1/99
Chapter 3
OPERATION & PROGRAMMING
Start-Up Procedure
1. Open the latch on the right side of the TPC-2 Control Unit and swing open the lid.
2. Two keys for the Programming Security feature should be attached to the inside of the
lid. Remove these keys and unwrap them.
lid. Remove these keys and unwrap them.
3. Insert one of the keys into the lock on the Display Panel. Assure the key is in the
UNLOCKED (key tab vertical) position.
UNLOCKED (key tab vertical) position.
4. Remove the key and place both keys in a secure location.
5. Turn ON the Control Unit by depressing the Power Switch in the lower left corner of
the Display Panel. The Power Switch is on a “rocker”. The “
the Display Panel. The Power Switch is on a “rocker”. The “
” side of the rocker should
be depressed to provide power to the Control Unit.
The LED Display should show a Pr-1 (-2, -3 or -4) and the green LED to the left of
MEMORY should be illuminated.
MEMORY should be illuminated.
Channel
/ Drive
1
2
Digit
System
Run / Stop
Value
Isolate From Supply Before
Removing Access Cover
Removing Access Cover
Drive 1
Drive 2
Trigger
ATS
Purge
T630
TPC-2
Memory
Event
Delay
Line
Gap (Spot / Stitch)
Stitch
Spike Time
Delay
Line
Gap (Spot / Stitch)
Stitch
Spike Time
Drive
A.T.S.
Drive
Trigger
Unlocked
Purge
Trig Mode
Time Range
Glue / Pass / Start
Palletising Count
Time Range
Glue / Pass / Start
Palletising Count