Sanyo SAP-KRV94EHDX 用户手册

Arm

Front panel

 

Flap

 

Screw cover

Screw

Screw

Grille

Front panel

Pin

Arm

Groove

Basically, these models can be installed and wired 

without removing the grille. If access to any internal 

part is needed, follow the steps as given below.

(1) Open the front panel until it is nearly horizontal, 

grasp the sections near the front panel arms on 

both sides, and then pull forward to remove the 

front panel. (Fig. 9)

(2) Remove the screw from the top right of the main 

unit. Also remove the screws where the screw 

covers are open. (Fig. 10)

(3) Press the 3 tabs on the top of the grille to 

disengage them. (Fig. 10)

(4) Pull the grille toward you to remove it. (Fig. 10)

(1) Insert the bottom of the grille into the flap, with the 

flap at a more-or-less horizontal position.

(2) While aligning both edges of the grille with the 

frame, move the panel horizontally and insert the 

top and bottom into the frame.

(3) Press the air outlet firmly with your hand to ensure 

no gap exists between the main unit and grille.

(4) Tighten the screws and close the screw covers.

(5) Grasp the sections near the front panel arms on 

both sides, hold the front panel so that it is nearly 

horizontal, bring the arm shafts into contact with 

the top of the grooves on the right and left sides of 

the air conditioner, and then push firmly until the 

arm shafts click into place. (Fig. 11)

(6) After closing the front panel, press firmly on the 

parts indicated by the arrows to securely fasten the 

panel in place. (Fig. 12)

Check that no gap exists between the main unit and 

grille.