Enviro EF3 用户手册

9

Operating Instructions

1.  Check and fill hopper with pellets.
2.  Make sure unit is plugged into a working outlet.
3.  Switch the power “ON” by pushing the start-up switch once 

only.

4.  Turn  knob  “B”  to  the  12  o’clock  position.  (Lower  grade 

pellets may need a higher setting on the feed rate). 

NOTE: Unit will take longer to light if the hopper has been 

completely emptied or is the first fire up.

5.  Wait until the fire is established, then turn “Knob B” to the 

desired heat output. The stove may not be able to burn in 

the BLUE ZONE if poor quality wood pellets are being used. 

Adjust  the  slider-damper  to  the  appropriate  setting  (see 

“S

LIDER

/D

AMPER

 S

ETTING

” section.

6.  If the stove should shut off after fifteen (15) minutes and 

there is still a fire in the firebox – press the start-up switch 

once more. If the fire went out, return to step 2 and re-light 

the stove.

KNOB “A”: Fan Controller.  By adjusting the knob you will vary the rate of airflow into the room by varying 

the speed of the convection blower. When you first start the stove, it should be placed in the “OFF” 

position in order to heat the unit as quickly as possible. Once the room has come up to temperature, the 

control may be set to a comfortable level. *Note:  The convection blower may cycle to high automatically 

depending on the setting of knobs “A” and “B”. This is a normal safety feature of the unit. 

SPECIAL NOTES: The flashing green light corresponds to the auger feed rate.

The scale on the Dial A Fire knob represents a range, not exact times.  Wood pellets of differing quality 

may affect the performance of the stove. If the stove has trouble operating at the ends of its’ range, 

turn the heat output knob back slightly.

KNOB “B”: Dial a Fire Heat Output Knob.  This knob controls the amount of heat output. The dial has a 

scale with the blue zone representing the coolest setting of the stove, and the red zone representing 

the hottest setting. The scale on knob “B” represents a range, not exact at times or fuel quantities.  

Wood pellets of differing quality may affect the performance of the stove.  If the stove has trouble 

operating at either end of its range, turn the heat output knob back slightly.

To turn your stove off, simply turn the HEAT OUTPUT knob (“Knob B”) counter-clockwise until the knob 

clicks to the “OFF” position.  This will stop the feed of pellets.  The blowers will continue to run and cool 

the stove.  When cool enough, the stove will shut down.

 

 DO NOT unplug unit while combustion fan