Husqvarna 324RX 用户手册
ASSEMBLY
14 – English
Assembling the cutting equipment
Fitting a blade guard, grass blade
and grass cutter
and grass cutter
•
Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.
fitting on the shaft and secure with the bolt.
CAUTION! Use the recommended blade guard. See the
Technical data section.
Technical data section.
•
Fit the drive disc (B) on the output shaft.
•
Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.
aligns with the corresponding hole in the gear housing.
•
Insert the locking pin (C) in the hole to lock the shaft.
•
Place the blade (D), support cup (E) and support flange
(F) on the output shaft.
(F) on the output shaft.
•
Fit the nut (G). The nut must be tightened to a torque of
35-50 Nm (3.5-5 kpm). Use the socket spanner in the
tool kit. Hold the shaft of the spanner as close to the
blade guard as possible. To tighten the nut, turn the
spanner in the opposite direction to the direction of
rotation (Caution! left-hand thread).
35-50 Nm (3.5-5 kpm). Use the socket spanner in the
tool kit. Hold the shaft of the spanner as close to the
blade guard as possible. To tighten the nut, turn the
spanner in the opposite direction to the direction of
rotation (Caution! left-hand thread).
Fitting the blade guard and saw
blade
blade
•
Remove the mounting plate (H). Fit the adapter (I) and
bracket (J) with the two screws (K) as shown. Fit the
blade guard (A) to the adapter using the 4 screws (L) as
shown.
bracket (J) with the two screws (K) as shown. Fit the
blade guard (A) to the adapter using the 4 screws (L) as
shown.
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is
fitted incorrectly it can result in serious
and/or fatal personal injury.
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is
fitted incorrectly it can result in serious
and/or fatal personal injury.
!
!
WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.
IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.
the machine must be equipped with the correct handlebar,
blade guard and harness.
G
F
D
B
C
A
E
A
L
I
J
K
H