Husqvarna 96732400200 用户手册

24

MAINTENANCE

Check every 200 hours. Check that wheels rotate freely. If 
wheels do not rotate freely take the unit to your dealer for 
service.
Foam filled tires or solid tires will void the warranty.
Removal and installation
Remove nut and caster bolt. Pull the wheel out of the yoke and 
take care of the spacers. Install in reverse order. Tighten caster 
bolt.

IMPORTANT INFORMATION  Adjust anti-scalp rollers with 
the mower on a flat level surface.
To avoid deck damage, the anti-scalp rollers must not be 
adjusted to support the deck.

Anti-scalp rollers are properly adjusted when they are just 
slightly off of the ground when the deck is at the desired 
cutting height in the operating position. Anti-scalp rollers then 
keep the deck in the proper position to help prevent scalping 
in most terrain conditions.
Anti-scalp rollers can be set in four positions. The rollers 
should be approximately ¼" (6.5 mm) from the ground. Do not 
adjust the rollers to support the deck.

Check every 100 hours of operation. Check for severe 
cracking and large nicks.
NOTE: The belt will show some small cracks in normal 
operation.
The belts are not adjustable. Replace belts if they begin to slip 
from wear.

Deck Belt Removal
1.  Park on a level surface. Apply park brake.
2.  Lower the deck into the lowest cutting position.
3.  Remove bolts from belt shields and remove shields.
4.  Remove any dirt or grass that may have accumulated 

around the cutter housings and entire deck surface.

5.  Loosen the nut securing the belt guide. Note the position 

of the belt guide for reinstallation.

6.  Push inward on the idler arm to release the tension on the 

belt. 

7.  Carefully lift the belt over the top of the cutter housing 

pulleys and remove belt from the deck.

1.  Wrap the deck belt around the electric clutch pulley 

located on the engine shaft.

2.  Route the belt forward and up onto the deck.
3.  Place belt around spring loaded idler pulley.
4.  Wrap the belt around the stationary idler pulley and 

around the mandrel housings.

5.  Push inward on the idler arm and carefully route belt over 

stationary idler pulley. Once the belt is properly routed, 
slowly release the idler arm to tension belt.

6.  Double check belt routing to make sure it matches the 

decal affixed to the deck, and the belt does not have any 

twist. Correct if needed.

7.  Tighten the belt guide and replace belt shields on both 

mandrel housings and secure with fasteners. 
NOTE: The belt guide should be perpendicular to the belt 
when installation is complete.