Husqvarna 96732400200 用户手册

25

MAINTENANCE

Leveling deck
Adjust the deck while the mower is on a level surface. 
Make sure the tires are inflated to the correct pressure. See 
Technical Data / Transmission. If tires are under or over 

inflated, the deck cannot be properly adjusted. Raise the deck 
to the highest (transport) position.
The deck should be adjusted slightly higher in the rear.
NOTE: To insure accuracy of leveling procedure, mower deck 
drive belt must be installed prior to leveling deck.
1.  Wear heavy gloves. Turn each blade tip to align front to 

rear with the deck side-to-side.

2.  Measure from the floor surface up to the bottom of the 

blade tip on the discharge side of the mower deck. 
Record the measurement.

3.  Move to the opposite side, check that measurement is the 

same. If adjustment is required—with a ¾" or adjustable 
wrench, turn the lift link adjustment nuts on either side 
counter clockwise to lower or clockwise to raise. Adjust 
until both measurements are equal.

4.  Turn either blade to align with the deck front-to-rear. If the 

front blade tip does not measure 

1

/

8

" to ½" higher in the 

rear—with a 

5

/

8

 or adjustable wrench, turn the nuts on the 

front suspension linkage. Clockwise raises the front of the 
mower, counter clockwise will lower the front. Adjust nuts 
until rear of mower deck is positioned level to 

1

/

8

" higher in 

the rear than the side-to-side measurement.

NOTE: This will place the mower deck in a standard 
measurement position. Depending on the type of grass 
being mowed or environmental conditions, additional 
adjustments may be required to achieve the desired cut. 

NOTE: For illustration, the front foot rest has been 
removed. The adjustment can be made without removal.