Husqvarna CTH151 用户手册

•      Remove discharge chute from rear of tractor.  Unhook  

the two (2) straps and pull chute out and away from 
tractor.

•      Remove the two (2) 3/8 nuts and fl at washers from the 

bolts at the tractor back plate.

•      Using the nuts and fl at washers removed from tractor 

back plate, install the bagger support tube to the back 
plate as shown. Tighten securely.

•     Install the two upper support brack 

ets through the 

back plate and to the  chas sis, using the 10 x 19 mm 
(3/8"x3/4") carriage bolts and locknuts sup plied. Tight en 
se cure ly.

•      Assemble both support brackets to the outside of the 

baggger support tube using two each 3/8 x 63,5mm 
hex bolts13/32" I.D. fl at washers and 3/8 locknuts from 
parts bag. Tight en securely.

•      Replace discharge chute into rear opening of tractor.  

Secure the chute with the two hook straps.

02277

02330

02590

02306

NOTE: The strap hook must go through the discharge chute 
only. Do not allow the hook to enter the slot in the tractor 
back plate. This will allow the dis charge chute to fl oat with the 
mower deck when moving on uneven terrain.

0259

2

NOTE:  For ease of assembly, you may wish to obtain the 
assistance of another person when putting the bagger 
to geth er.
•      Holes in front bagger tube are at an angle. Place front 

bagger tube against lower bagger tube and check for 
proper hole alignment before assembling bolts.

•      Assemble front and lower bagger tubes using four (4) 

1/4 x 50,8mm carriage bolts and lock nuts supplied. 
Tighten se cure ly.

•     Slide front and lower bagger tube assembly into the 

bagger assemby.

•      Assemble front and upper bagger tubes using four (4) 

1/4 x 50,8mm carraige bolts and lock nuts supplied. 
Tighten se cure ly.

•         Start the engine. After engine has started, move throttle 

control to idle position.

•      Release parking brake.
•      Slowly move the mo tion control lever for ward and slowly 

drive tractor off skid.

•      Apply brake to stop trac tor, set parking brake and place 

motion con trol lever in neutral po si tion.

•      Turn ignition key to "OFF" position.
Continue with the in struc tions that follow.