Roland VS-1824 用户手册
114
Chapter 8 EZ Routing
Using EZ Routing Step Editing
EZ Routing Step Editing walks you through the necessary
setup procedure for recording, mixing, bouncing and
mastering. As you begin your setup, the VS-1824 presents the
first screenful of parameters that must be set. When you are
ready, press [F2 (STEP)] to proceed to the next set of
parameters until the entire setup is complete. Step Editing
can help you learn how the VS-1824 works and is therefore a
great tool for beginners.
setup procedure for recording, mixing, bouncing and
mastering. As you begin your setup, the VS-1824 presents the
first screenful of parameters that must be set. When you are
ready, press [F2 (STEP)] to proceed to the next set of
parameters until the entire setup is complete. Step Editing
can help you learn how the VS-1824 works and is therefore a
great tool for beginners.
When you have finished your setup, you can save it as an EZ
Routing template. The following pages describe how to use
EZ Routing Step Editing.
Routing template. The following pages describe how to use
EZ Routing Step Editing.
Setting Up for Recording Using
Step Editing
Step Editing
Select this when you want to make a new recording from a
source connected to one of the INPUT jacks. If you wish to
cancel the settings procedure, press [F6 (EXIT)].
source connected to one of the INPUT jacks. If you wish to
cancel the settings procedure, press [F6 (EXIT)].
1. Press [EZ ROUTING].
The EZ Routing icon appears in the display.
2. Press [F5 (Exec)].
If “Exec” does not appear in the display above [F5], press
[PAGE] until you see “Exec,” and then press [F5 (Exec)].
[PAGE] until you see “Exec,” and then press [F5 (Exec)].
fig.02-18
3. Press [F1 (Rec)].
4. Specify which input source is to be recorded to each
track. To do this, first press the Input SELECT for the
input you want to use, then press the Track STATUS
button for the track you want to record on. Using this
method, you can assign a single Input to two different
input you want to use, then press the Track STATUS
button for the track you want to record on. Using this
method, you can assign a single Input to two different
tracks for recording. Use [
] and [
] to move the
cursor and the TIME/VALUE dial to select the V-Track
on which you want to record.
on which you want to record.
* You cannot assign a DIGITAL input to more than one stereo-
linked pair of tracks.
* Using EZ Routing, it is not possible to assign a stereo-linked
input to tracks that are not linked. For example, to record the
DIGITAL input on Tracks 3 and 4, you must first turn
Channel Link on for Track 3.
DIGITAL input on Tracks 3 and 4, you must first turn
Channel Link on for Track 3.
fig.02-19
5. Press [F2 (STEP
→
)].
6. Only the source and destination channels you specified
during Step 4 will be shown. Use [
], [
], [
],
and [
] to move the cursor and the TIME/VALUE
dial to adjust each of the values.
fig.02-20
7. Press [F2 (STEP
→
)]. You can return to the previous
screen by pressing [[F1 (STEP
←
)].
Source assigned to the MIX bus
Source assigned to the track
Source
Track
V-Track
Pan/Balance
Level
Output destination
(MIX us or track)
(MIX us or track)
Cursor