Roland XV-88 用户手册

As soon as you press [ARPEGGIO] to turn the Arpeggiator 
on, the keyboard will be set to play arpeggios so 
conventional keyboard playing is no longer possible.

If you split the keyboard into two different areas, you can use 
one area for normal playing and the other for playing 
arpeggios. This setting, for instance, allows you to play 
arpeggios with the left hand and a melody with the right 
hand.

1. Press [PERFORM] to call up the PERFORM PLAY page.

2. If you have selected a Single Performance, set the Key 

Mode parameter (ZONE/COMMON/ZONE 
COMMON) to LAYER (p. 58).

3. Set the Local switch of the Zone linked to the Part you 

4. After pressing [ZONE] to make the indicator light up, 

press the [ARPEGGIO] function button followed 
by

to display the ARPEGGIO page like the one 

shown below.

fig.04-14

5. Use the cursor buttons to move the cursor to “Zone.”

6. Rotate the VALUE dial or press [INC/+]/[DEC/-] to 

select the Zone linked to the Part for which arpeggios are 
to be played.

7. Press [KEY RANGE] in the Function buttons to display 

the KEY RANG page.

fig.04-07

8. Set the key range (expression range) for the Zone. Use 

the cursor buttons to move the cursor to “Lower” and set 
the lowest note of the range. Move the cursor to “Upper” 
and set the highest note of the range.

9. Rotate the VALUE dial or press [INC/+]/[DEC/-] to 

specify the range of notes.

10. Turn off the [EDIT] indicator, and press a Function 

button to select a Zone linked to a Part other than the one 
for which arpeggios are played. When the [1-8/9-16] 
indicator is out, you can select zones 1–8. When the [1-8/
9-16] indicator is lit, you can select zones 9–16.

11. Set the key range of the Zones linked to the Parts other 

than the Part for which arpeggios are played so that this 
range does not overlap with the key range over which 
the arpeggios are played.

12. When you are finished making settings, press [EXIT] to 

return to the PERFORM PLAY page, and begin playing.

If you play arpeggios using a Layer Performance 
without setting the key range, then with Parts other than 
the Part linked to the Zone specified by the Zone 
parameter (ZONE/ARPEGGIO/ARPEGGIO), only the 
sound for the key being pressed is played.

If you hold down [ARPEGGIO] and press [TRANSPOSE], 
and get the indicator to start blinking, the arpeggio will 
continue to be played even if you release the chord.

1. Hold down [ARPEGGIO] and press [TRANSPOSE] to 

make the indicator blink.

2. Play a chord.

3. If you play a different chord or notes while the arpeggio 

is being held, the arpeggio will change accordingly.

4. To cancel Arpeggio Hold, hold down [ARPEGGIO] and 

press [TRANSPOSE] simultaneously once again.

If you play an arpeggio while pressing the hold pedal, the 
arpeggio will continue to be played even if you release the 
chord.

1. Connect an optional pedal switch (DP-2, DP-6, etc.) to the 

HOLD PEDAL jack.

2. Press [ARPEGGIO] to turn the Arpeggiator on.

3. Play a chord while pressing the hold pedal.

4. To play another chord, release the pedal, press it again as 

you play the next chord.