Roland XV-88 用户手册

You can simulate a rhythm guitar by following the procedure 
below. By using the Palette Slider, it is also possible to apply 
a wah effect as you play.

1. Select a guitar Patch.

2. Press [ARPEGGIO] to turn the Arpeggiator on.

3. Set the Style parameter (SYSTEM/ARPEGGIO/

ARPEGGIO) to one of RHYTHM GTR 2–5.

4. Press [FILTER/ENV] to make the indicator light.

5. Move the [CUTOFF] slider or [RESONANCE] slider 

while you play a chord.

The XV-88 can also produce arpeggios with incoming Note 
messages from an external MIDI device.

1. Use a MIDI cable to connect the MIDI IN connector of the 

XV-88 to the MIDI OUT connector of the external MIDI 
device.

2. Press [PATCH] to access the PATCH PLAY page.

3. Press [ARPEGGIO] to turn the Arpeggiator on.

4. Press [SYSTEM] to make the indicator lit, press the 

[MIDI] function button, and then press

to access the 

PATCH MIDI page.

fig.09-06

5. Use the cursor buttons to move the cursor to “Remote.”

6. Rotate the VALUE dial or press [INC/+]/[DEC/-] to 

turn the setting ON.

7. Play the external MIDI device.

There are a total of 9 parameters that can be set for the 
Arpeggiator, but the most important is the Style parameter 
setting. The arpeggio pattern is largely determined by this 
setting.

When you set the Style parameter, the Motif, Beat Pattern, 
Accent Rate and Shuffle Rate parameters will automatically 
be set to optimum settings. After selecting the style, you can 
also set parameters such as Octave Range and Key Velocity.

If this selection does not provide the pattern you want, 
modify the settings of the Motif, Beat Pattern, Accent Rate 
and Shuffle Rate parameters to add variations to the style as 
desired.

• When you make the settings in Patch/Rhythm Set/GM 

mode, Motif, Beat Pattern, Accent Rate and Shuffle Rate 
parameter settings will be lost if you select another style 
and then turn the power off. However, in Performance 
mode, you can save them to each Performance as the 
Performance parameters.

• The values you can set with the Motif or Beat Pattern 

parameters are normally limited by the selected style. 
Only when the Style parameter is set to LIMITLESS will 
all values be acceptable.

1. Access the ARPEGGIO page.

Press [SYSTEM], getting the indicator to light, and then 
press the [ARPEGGIO] function button.

Press [ZONE], getting the indicator to light, and then 
press the [ARPEGGIO].

fig.04-11

For details regarding each parameter, refer to 

2. Move the cursor to “Style” and specify the style you 

want.

3. Move the cursor to “Octave Range” and specify the key 

range over which you want arpeggio.