Roland XV-88 用户手册

4. When changing the sound generator to be controlled 

with the D Beam Controller, hold down [ON] to display 
the D BEAM CONTROL page, move the cursor to 
“Output,” then make the setting.

fig.02-20

Set the output to INT when controlling only the internal 
sound generator, to MIDI when controlling an external 
sound generator, or BOTH when you want to control 
both internal and external sound generators. When 
controlling neither the internal nor any external sound 
generator, set this to OFF.

This setting is linked with the Output parameter.

Output parameter (SYSTEM/D BEAM/D BEAM 
CONTROL) (p. 176)

Output parameter (ZONE/D BEAM/D BEAM 
CONTROL) (p. 63)

5. When changing the D Beam Controller’s polarity, hold 

down [ON] to display the D BEAM CONTROL page, 
move the cursor to “Polarity,” then make the setting.

fig.02-21

With a setting of REVERSE, the direction of control for 
the D Beam controller will be inverted.

This setting is linked with the Polarity parameter.

Polarity parameter (SYSTEM/D BEAM/D BEAM 
CONTROL) (p. 177)

Polarity parameter (ZONE/D BEAM/D BEAM 
CONTROL) (p. 63)

6. When changing the range to be controlled by the D Beam 

Controller, hold down [ON] and press

to display 

the D BEAM RANGE page, move the cursor to “Lower” 
or “Upper,” then make the setting.

fig.04-17

Set the lower limit for the range with the Lower 
parameter, and the upper limit for the range with the 
Upper parameter.

It is not possible to set the lower limit value above the 
upper limit, nor can you set the upper limit value below 
the lower limit.

This setting is linked with the Lower, Upper parameter.

Lower, Upper parameter (SYSTEM/D BEAM/D BEAM 
RANGE) (p. 177)

Lower, Upper parameter (ZONE/D BEAM/D BEAM 
RANGE) (p. 64)

7. When changing the sensitivity of the D Beam Controller, 

hold down [ON] and press

to display the D BEAM 

SENS page, then make the setting.

fig.04-18

The higher the value set, the more readily the D Beam 
Controller goes into effect. Ordinarily, this is set to 5.

This setting is linked with the D Beam Sensitivity 
parameter.

D Beam Sensitivity parameter (SYSTEM/D BEAM/D 
BEAM SENS) (p. 177)

D Beam Sensitivity parameter (ZONE/D BEAM/D 
BEAM SENS) (p. 64)

8. You operate the D Beam Controller by moving your 

hand over it, as you produce sounds by playing the 
keyboard.

9. To turn off the D Beam Controller, press D BEAM 

CONTROLLER [ON] once again, extinguishing the 
indicator.

By holding down [SHIFT] and pressing D BEAM 
CONTROLLER [ON], you can display each of the 
settings pages without having to hold down [ON]. To 
return to the original window, press [EXIT].