Roland 04672434 用户手册
43
Chapter 3 Global Device Settings (SYSTEM)
Chapter 3
This setting determines whether or not the current settings for each
controller (the expression pedals, the FC-300’s expression pedals,
control pedals or other controllers) are applied to the patch when
patches are switched.
controller (the expression pedals, the FC-300’s expression pedals,
control pedals or other controllers) are applied to the patch when
patches are switched.
*
Assign Hold is not performed when the SW MODE parameter in
Control Assign Source is set to LATCH. (LATCH toggles between
the minimum and maximum value each time the switch is pressed.)
1.
Press [SYSTEM].
2.
Press PAGE [
] to display Page 1.
3.
Press [F4] (CTL).
4.
Press PAGE [
] to display Page 2.
The Control screen appears.
5.
Select ON or OFF for the Assign Hold function
with [F1] (OFF/ON) or the F1 knob.
with [F1] (OFF/ON) or the F1 knob.
1.
Press [SYSTEM].
2.
Press PAGE [
] to display Page 1.
3.
Press [F4] (CTL).
4.
Press PAGE [
] [
] to display Page 2.
The Control screen appears.
5.
Set the DIRECT EDIT parameter to SYSTEM
with [F2] (SELECT) or with the F2 knob.
with [F2] (SELECT) or with the F2 knob.
If you want to be able to assign the functions for the
knobs on an individual patch basis, set DIRECT EDIT to
PATCH. With DIRECT EDIT set to PATCH, the unit
operates in accordance with the assignments set in each
patch, as described in
knobs on an individual patch basis, set DIRECT EDIT to
PATCH. With DIRECT EDIT set to PATCH, the unit
operates in accordance with the assignments set in each
patch, as described in
6.
Press Page [
] to go to the page for the knob
you want to set.
7.
Use the [F1]–[F6] or F1–F6 knobs to select the
parameters you want to assign to the knob.
parameters you want to assign to the knob.
You can quickly locate and select the desired parameter
by first narrowing down the parameter type with F1
(F4), then using F2 (F5) and then F3 (F6) to reach the
right parameter.
by first narrowing down the parameter type with F1
(F4), then using F2 (F5) and then F3 (F6) to reach the
right parameter.
Having Values from an
External Pedal, GK VOLUME
Control, or Other Controller
Carried Over When Patches
are Called Up (ASSIGN HOLD)
External Pedal, GK VOLUME
Control, or Other Controller
Carried Over When Patches
are Called Up (ASSIGN HOLD)
Settings
Explanation
ON
Current values of controllers are applied when
patches are called up.
patches are called up.
OFF
Stored values (at the time of Patch Write) of
controllers are used when patches are called
up. (Current controller values ignored.)
controllers are used when patches are called
up. (Current controller values ignored.)
Making System-wide
Settings for the Features
Controlled by the Function
Knobs (SYSTEM DIRECT EDIT)
Settings for the Features
Controlled by the Function
Knobs (SYSTEM DIRECT EDIT)
VB-99_e.book 43 ページ ２００８年８月１８日 月曜日 午後１時１０分